Close and tight fitting are the terms usually given to a full face mask, a half mask or a filtering face piece that relies heavily on the quality of the fit of the face piece to the wearers face. Loose fitting face pieces include visors, helmets, hoods and blouses.
If you sit your breathing apparatus course at CSTS we can offer a limited number of tests on the day you attend for your course. However, these are limited to early morning (prior to course start), during breaks and early evenings (after your course finishes). As you can appreciate delegates cannot miss out any of the course content and because it takes up to a day to test a course full of delegates it is just not possible to test everyone on the day of their course. To arrange a test on the day of your course, just speak to a member of the training team who will be happy to arrange this for you.
Yes. All close fitting masks, or in other words masks that work by creating a seal to your face need to be tested. If your escape set is a hooded set then the hood is classed as loose fitting (not close fitting) and therefore does not require a test.
No. In fact it is the other way around. During the fit test you will be assessed on how well you fit the mask to your face so it is important you are competent in donning (putting on) procedures prior to the test.
Yes - the test is not a fitness test or a health check. The test is to determine how well the mask fits your face, NOT if you are fit enough to wear the mask. Operatives do not have to be super fit to take the test but they will be expected to walk (not run) on a treadmill or step up and step down slowly for about 10 minutes. If you have a cold then this can affect the test results (an increased number of particles in the mask!) - just speak to your tester who will be able to advise you.
Yes - during the breathing cycle (particularly during heavy exertion) you breathe faster in and out in the middle of your breath. This is known as peak inhalation/exhalation. During this period it is possible to 'over breathe' the set which will then momentarily operate in negative pressure in relation to the outside atmosphere.
One of the pre-use checks for a face mask involves checking the seal by creating a negative pressure inside the mask and causing the mask to 'suck' onto the face. This is a very quick test and does not take account of the movements a wearer makes during the course of their work or the effects of pressure inside the mask once working. The only accurate method of testing for a seal is to carry out a formal face fit test.
The supporting guidance for COSHH (Control of Substances Hazardous to Health), CLaW (Control of Lead at Work) and CAR (Control of Asbestos Regulations) recommends face fit testing as a method of ensuring an adequate face seal. The HSE document OC 282/28 (Fit Testing of Respiratory Protective Equipment Face Pieces) lays down the protocol for carrying out face fit testing.
Tight fitting face pieces rely on achieving good contact between the wearer's skin and the face seal of the face piece. As people come in different shapes and sizes it is unlikely that one type of mask will fit everyone. A poor fit will reduce the level of protection and may lead to immediate or long term ill health of the wearer. A fit test is also useful for checking that the wearer can correctly don (put on) the face piece.